Hw-module Slot R0 Reload
Reload: Reloads the operating system for the entire device Note: For the Nexus 7000, this command works only in the default VDC.! 6500 hw-module module slot reset! 4500 no hw-module slot module number power hw-module slot module number power. Reload module mod-# Reloads a module in the device by turning power off then on. Eg:%CMRP-3-CHASSISMONITORONLINETIMEEXCEEDED: R0/0: cmand: Reloading slot because it has failed to come online Conditions: The module that's failing to boot may have been newly inserted and may have not been upgraded to ROMMON version 16.2(1r) to be consistent with other cards in the router chassis. This older ROMMON will not be.
- Hw-module Slot R0 Reloading
- Hw-module Slot R0 Reloaded
- Hw-module Slot R0 Reloadable
- Hw-module Slot R0 Reloader
I have a test 7507 with rsp-k4pv-mz.120-32.S8.bin on both RSP2s. I've done
this:
service single-slot-reload-enable
redundancy
no keepalive-enable
mode sso
And it doesn't seem to ever sync the slave
ranttest#show red
Redundant System Information :
------------------------------
Available system uptime = 14 minutes, 49 seconds
Switchovers system experienced = 0
Standby failures = 0
Last switchover reason = none
Hardware Mode = Duplex
Configured Redundancy Mode = sso
Operating Redundancy Mode = hsa
Maintenance Mode = Disabled
Communications = Down Reason: Simplex mode
Current Processor Information :
-------------------------------
Active Location = slot 2
Current Software state = ACTIVE
Uptime in current state = 13 minutes, 24 seconds
Image Version = Cisco Internetwork Operating System
Software
IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(32)S8, RELEASE SOFTWARE
(fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by cisco Systems, Inc.
Compiled Mon 20-Aug-07 16:34 by leccese
BOOT =
CONFIG_FILE =
BOOTLDR =
Configuration register = 0x2102
Peer (slot: 3) information is not available because it is in 'DISABLED'
state
ranttest#redundancy force-switchover
Hw-module Slot R0 Reloading
Hw-module Slot R0 Reloaded
Cannot perform switchover until the standby is fully initialized.The box is up, its got two OSPF adjacencies, maybe a hundred routes - its
Hw-module Slot R0 Reloadable
not doing anything fancy, so I'm kind of stuck here. The production targetis 7507s /w RSP4s, the same OSPF, and about 180k routes via BGP. Any idea
what might be wrong here?
_______________________________________________
cisco-nsp mailing list cisco-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
Hw-module Slot R0 Reloader
archive at http://puck.nether.net/pipermail/cisco-nsp/